0 Items
Sale!

Scissor & Boom Lift Training and Certification

$450.00 $375.00

Starts: To Be Announce
Please Call 718-395-4110

Scissor Lift

 

Scissor & Boom Lift Training and Certification

Aerial Platform Lifts (A.P.L.) : Scissor lift and Boom Lifts are reliable mobile elevating work platforms used by workers to reach elevated work locations in a variety of industries and applications. A.P.L. certification requires careful consideration of the equipment specifications and standardizing safe operator practices through effective training.

According to an OSHA study, the three largest issues contributing to A.P.L. injuries and deaths were employers’ failure to address:

  • Fall protection
  • Stabilization
  • Positioning

In order to protect associates from safety hazards linked with these three areas, employers must ensure that only properly trained operators are permitted to use the lifts. Operators should be able to demonstrate proper use of the lift. Trained associates should complete pre-operation checks of the A.P.L., follow manufacturers’ instructions, use personal protective equipment (PPE) where required and ensure any maintenance needs are addressed before use.

Fall Protection

Guardrails are required to be installed on A.P.L.s to prevent falls. Operators should always check guard rails prior to operation of the A.P.L., never stand on the guard rails and never lean over the guardrails to reach tasks.

Stabilization

Stability of the A.P.L. work platform is essential for safety. To reduce the risk of tip-overs, operators and employers should:

  • Isolate the A.P.L. from traffic and other moving worksite equipment to prevent impacts
  • Ensure work locations have a firm, level surface away from hazards
  • Only use the equipment when weather conditions meets requirements labeled on the equipment or found in the operator’s manual.

Positioning

A.P.L. operators should be aware of hazards that can contribute to tip overs, crushing and electrocution. Operators should exercise the utmost caution when:

  • Operating a A.P.L. near a stationary object
  • Operating closely with mobile equipment
  • Passing below fixed objects like door frames and ceiling beams

Due to risks with arcing electricity, operators should not use A.P.L.’s within 10 feet of power lines, transformers or other utilities. If the job absolutely requires work near these electrical sources, the worker should be properly trained and certified and the utility provider should be contacted before work begins.

Maintenance

In addition to regular, planned maintenance, A.P.L.’s must pass a pre-operation inspection. Operators should inspect and test controls and components, inspect guardrails and ensure brakes are set properly before each and every use. Daily pre-inspection items can be found in the operator’s manual.

 

Additional information

Date / Fecha

Monday – Thursday 8:00am – 4:00pm

Location

Start Date

04/06/20

Language

English, Espanish

Language-En

English